Thank you, Blazer!
I spent some time this weekend tweaking the front bumper even more. I think I'm finally set with the front bumper. I had to add material back to my lower bumper brackets as they seemed to be torquing it funny. It kept pulling the bumper to the left which made it go off center. Of course, getting the bumper finally set meant adjusting the hood again, and then that made the cowl panel not fit anymore, so I was back to square one with that. I had to hammer down my inner cowl panel to make the outer cowl panel sit level. Also, one corner is pinching so I had to trim it back. I'll weld it later.
I also started making my rear brake vents. So far I only formed some metal, but I will need to get the actual ducting I plan to use before I go further with it.
|