Quote:
Originally Posted by BBC71Nova
I'm not sure what the final outcome of this will be but I needed to get some tie-rods on the car. I ordered up some "high strength, extra thick washers" from McMaster-Carr along with some .5" longer hex flat head bolts for the steering arms. The washers measure about .2" each so I went with a stack of 2. The front bolt is the one that came with the Ridetech spindles. It just barely gets into the nylon "lock" after installing the spacers so I'll probably go ahead and replace those with the longer bolts as well. The rear bolts are the new longer ones I ordered.
The above combination achieves much needed clearance between the steering arm and the rim lip. The tie-rod itself is still only 5/16" or so from the tire. Under side loads I could see this rubbing. Adding the spacers also put the limit stops closer to the stops on the control arms thus limiting steering. Not a huge concern of mine at the moment given the tires almost get into the fender lips anyway. I need to install the swaybar to make sure nothing gets into the end-links.
Here are some before and after pics.
 |
The other option would be to order a set of Baer Trackers
http://baer.com/products?page=shop.b...egory_id=15956
I had a similar problem with my front wheel ( wrong back space with drop spindles )