It's typically said that the harmonics induced by a gear drive will contribute to premature failure of the roller bearings in the lifters. I don't have any data to support this conclusion, I've just heard it from many people who don't have any real life experience to back this up. So it may be true or it may be an "old wives tale"... hopefully someone with some real answers will chime in.
I'm not a huge fan of gear drives to begin with, both for the noise and the harmonics they introduce into the valvetrain. You're much better off with a good true double roller chain or a belt drive. The belt drives have been out long enough now to prove themselves reliable pieces, they even have some street versions. Just run a "dry" belt setup with a debris shield and check it every 10K miles or so. Easy cam timing adjustment, even less harmonics transmitted to the cam/valvetrain than a chain, etc. A bit more to go wrong than a good chain, but they're good pieces.
Troy
__________________
1969 Chevelle
Old setup: Procharged/intercooled/EFI 353 SBC, TKO, ATS/SPC/Global West suspension, C6 brakes & hydroboost.
In progress: LS2, 3.0 Whipple, T56 Magnum, torque arm & watts link, Wilwood Aero6/4 brakes, Mk60 ABS, Vaporworx, floater 9" rear, etc.
|