Quote:
Originally Posted by Roberts68
What sort of setup table does your HTP MIG200 have? I am used to a nice chart inside the wire compartment on a Miller 252. Would you be willing to post a picture of yours at all please?
Also, how do you like the heat setting adjustment being what appears to be a 2 switch analog arrangement?
Thanks once again,
Robert
|
The 2-switch set-up is not as simple as my Lincoln 135+............basically it is 6 main power settings of which each can be fine tuned 4 levels. Wire feed is the critical/finicky setting with the machine. I'm running .023" wire for most applications.