[INTMD8]

Ok, on to the rears. Much easier install here. Regulators mounted via an "L" bracket to the floor just ahead of the trunk hinge structure. Of course all mounting points will be reinforced. Pass-through hole cut in rear deck where bezel mounts were welded in. Put matching holes in the rear package tray and attach bezel. Looks nice I think! Not as clean as no seat belts at all but I like the idea of having them. The metal latch plates can be slid down between the seat cushions when not in use so the only thing you would really see when parked is the bezels and belts.

I'm having all the bezels made in aluminum which will then be chromed to match everything else in the interior. Front bezels will be made on a radius to match the seat curvature.

I picked up some mid 60's Cadillac belts and will have everything re-webbed jet black and put together with the vintage latches. Too bad I couldn't get the same pattern on the belt material as the seats, might blend in better.