[novanutcase]

I wasn't sure since I've had so many conflicting opinions although your son mentioned that you do paint and body for a living so I think I will take your advice. Where can I buy aircraft paint stripper? I guess I will need to completely tear down the body. You know, doors off trunk lid and entire front clip. As far as the inside of the car, would you suggest I also strip this down to bare metal? After I pulled the front fenders and hood off I noticed that the driver side cowl had been dented in. What do you think would be the best method for straigtening this? Do you think it would be best to just weld in a new section rather than trying to straighten the section? I included a few photos so you can see the damage. I put two photos of the damaged drivers side and two photos of the correct passengers side.