Good Morning All,
I want to thank Guy at Rockford Racecraft for getting my Rods & Pistons for my Motor. I dropped off the Block, Camshaft, Timing Chain & Cover and the Balancer (thank John Waller). So we could get started building the motor.
Dave was only able to spend a couple hours on the truck last week. So not much was done. He was able to get the bracing started behind the dash for the steering column, brake pedal and the vintage air. We are going to put tabs on the rod so we can anchor the wire harness to it to keep the underside of the dash clean.
Here is a close up of the pedal brace
