Looked today and the pinion is offset in the housing to the pass side 1/2''-3/4''. Which is exactly how much it is off center in the trans tunnel. The axel center line is in the center of the trans tunnel and thats what DSE wants you to measure off of. Just want to much sure the u joints will be fine because it the housing is already angled down -2 deg. I read a lot on line that all GM pinions are offset to the pass side by a 1/2''. I'm mocking up my wheels and tires next and just want to make sure the rear end is where it needs to be. I dont want to run any spacers or anything. I'll call DSE tomm and ask them. Just thought others may have noticed the same thing. Open to any input. Thanks Bill
|