Quote:
Originally Posted by Vince@MSperfab
That would depend on your build. If you are building a rear end anyways, choose your wheel first with your dish preference and start fitting. It's best to measure your car because from experience no two cars are alike.
|
, so how do i work out my dish or backspace without a diff to measure from? Im after maximum dish i can run..with a 12 inch rim.
I had a measure of my diff today ,, its a tru trac moser ,, it has big drums,, did they use ford rear brakes on some of these? Im sure i saw a ford logo stamped into the backing plate somewhere when i purchased it? will that be a factor with getting rear discs or are the axle flanges the same stud pattern?
sorry i got a lot of questions here ,, i also thought narrowing each side 2.5 would bring the saddles very close to the axle flange..
Gav