More Dynamat hell... I have about 2.5 days into it so far, and I've got one more small section on the rear tunnel, then the doors. Note the plastic buckets that I siliconed into the kick panels. Those will protect the speakers that are going down there. 3 days later, and the backs of my hands are still covered in the stuff. I think it's as bad as POR-15 if you get it on your skin!
And a lot more ordering has been ongoing also! I decided to replace the side glass on the car, and both sides have scratches (the driver's much worse though). I did a lot of searching, and I couldn't find a definitive answer as to whether the Pilkington glass was really better, and who made it. So I went with Auto City Glass. Hopefully it will arrive this week, and I can install the glass this weekend. Then I can Dynamat the doors...
I'm excited that UPS is showing my Forgelines are supposed to arrive tomorrow! Now I just have to find a place to have them mounted that I can trust not to screw them up...
Maybe SW will have a recommendation, he's had a set or two mounted in town.
Eric wrapped up the firewall and painted it last week. We also sent a big pile of parts to the powder coater, hopefully they are coming back this week also.
Here are a few pictures for the week:
The rearend is out as Eric touched up some spots on the bottom of the car. It's a good shot of the JRS setup I have for adjusting the pinion angle:
Some Dynamat shots:
And the firewall:
