I pulled this motor from my 67 Camaro in favor of an LS1 swap. I have video of the motor running when it was pulled. Been in my garage taking up space since. Motor runs well, but has been sitting for a while. Here's the specs on the motor. Everything was the best of the best when the motor was built.
4bolt main 400 block, .020 over 10.5:1 CR
Forged Steel Crank (350) I think it's knife edged
Wiseco 377 pistons, 5.7 pink rods
Crane Fireball Cam
Chevy 441 heads, opened up for 2.02/1.90 valves, Stainless swirl polished tulip valves. Heads are ported and port matched.
Edelbrock tourqer (original style) intake with 650 holly Mech carb.
HEI small cap distibuter.
Brand new clutch still bolted on
This motor will scream! not the torquiest motors at the bottom, but will pull past 7k if you dare. Complete motor from Carb to the header collectors. Moroso chrome valve covers, chrome timing chain cover and chrome oil pan. You even get the roll around engine stand it's sitting on!
Located in Virginia Beach, VA I'm asking $2500 for everything.
https://www.youtube.com/watch?v=MVFgb1UG4L0