The height depends a LOT on the sliders/mounting brackets. My Arizen seats came with some low profile sliders. They added very little height to the seat. The sliders bolt to (2) 1/4" thick metal plates and then you measure and drill holes in the plates to bolt them to the floor, and use some shims under the plates to level the seats. It's a very tight fit because of the clearance of the seat to the floor but it works if fine if you get all the measurements just right. My dad is 6'2", about 220, and he had no issues driving the car, other than putting my rev limiter to the test too often.
__________________
Chris Robinson
1969 Camaro SS/RS, 489 ZL-1 MPFI, T-56 Mag
|