[Lenie]

So yesterday I lost the clutch, quick peek under the hood and I noticed the pivot arm to the clutch fork was hanging and appeared to have just backed out of the clutch fork dimple. I'm using the heim set up. So this morning I put the car back up on cribbing, put the pivot arm back in the fork, locktite it, lower the car back down, get in the car, depress the clutch and it falls back out. A little bummed I get back out take a look at the linkage and didn't notice the first time around the zbar arm actually slid out of the bracket that's connected to the frame. Has this ever happen to anyone? I can just put it back together but I don'g want it happening again. Wondering if I should just weld something across the top of the slot opening to keep it from sliding up and out again. Factor piece I wouldn't think would have this problem, maybe I'm a little misaligned? Any ideas