Quote:
Originally Posted by Rhino
There are a LOT of measurements that need to be compared prior to calling the rack a good match. Personally I haven't run across a single OEM rack I'd feel comfortable putting on the stock 1st gen sub without significant other changes.
How close is the inner ball joint to inner ball joint measurement of the rack compared to the frame side pivot points of your lower control arms?
|
Its bang on the same distance, it would be nice if the rack was 5mm longer each end as the rack will sit about above the pivot points of the lower control arms so the tie rods stay parallel, but bump steer will be minimal. Im not going to worry too much about ackerman.