Well, started on the narrowing process and I could use some advice here. This is the first time I've done this; I've measured a bunch of times and have the length where it needs to be. The main issues I ran into is that the new ends do not seem to line up that great with the axle tubes. They are off a little bit, almost like the housing tubes are a bit out of alignment.
As it sits right now, the new ends are lined up with the alignment slugs in the center chunk, so basically the rod going through the 4 slugs is straight while the new ends are tacked on slightly off. Is it ok to weld them on like this?
I assume the axles being centered to the carrier is the most important thing?
Thanks
Here are a few pics:
|