When reading through the start of this thread i was gonna ask a question about how the exhausts were going to pass through the frame at the rear loop in relation to the floor, as a pic later on showed the floor sitting right in the middle of where you had the holes in the frame for the exhaust.
I see you changed it though to just a recess in the bottom of the frame instead of passing through it, could you have also raised the floor a bit in the rear to still pass through the frame? or is the way you have done it still kept the exhaust pretty horizontal through that area without having to dip down around the frame.
Just asking a question without going back through the thread to find the pics, not sure if anyone else picked up the change either.
__________________
Aussie Adam
|