What the Halibut? Really ... Chassisworks can't even get a mini tub correct
Take a look and see for yourself, (sorry for the really big pixs) I marked at 2" and folded over @ 2.75" and had to cut up over the shock tower and floor pan at 2.75" (too many layers to fold and the rail in way).
Something doesn't look right!
Can you see the 2" mark and where I bent the flange @ 2.75!
This is the measurement I took BEFORE 9.25 + 2.75 = 12 RIGHT?
All is clamped right!
I measured the pass side and it's the same ... not gonna be good!
If the is a Chassisworks rep reading this I would like some answers .... please reply.
Should have just ordered from DSE