Quote:
Originally Posted by WSSix
How timely. I was just thinking of messaging Tobin to see if I had any options with his parts should I decide to go with a C clip eliminator kit on my 10 bolt. Do you have any pictures or info you can share on the process, Marty?
Thanks
|
Hi Trey
I know this is going to be hard to believe but these are the only pictures I took.
Info "Only Some"
1. Yank the axles and cut off the end where the "C" clip would attach
2. Press on the new bearings and bracket from Moser
3. Cut Tobin's Caliper Brackets to make it a "C" so it can slide around the axle flange.
4. Machine a couple new Caliber Shims
5. Install caliper - Check clearance and axle end plate
6. Push car onto trailer and say goodbye as Kenny drives away with it.
Now on a side note: I received an email from a gentlemen and he warned me that the Moser ends are designed for only straight line use and could fail. Anyone have any thoughts on this ????
Mind you this car is actually being build to be driven with very limited auto-cross.