Quote:
Originally Posted by Old66Tiger
Yup, I was driving the car down the road before I pulled the front end apart and swapped the SpeedTech stuff over for the Ridetech stuff. The Speedtech with factory spindles needed 3/16" shims to get -0.5 degrees of camber at the same ride height. I made up 5/8" of shims out of oak (just to see where the camber would end up and I am still in the positive area. Car is not dragging weeds. About 2" lower than factory at best.
Apparently, these arms just went through a complete re-design. I also now need to grind my inner fenders to allow clearance for these arms.
|
Now why would you go and do that???