[Musclerodz]

For chromabase or deltron red it is $600 a gallon, $300 gallon for clear, activator and reducer. $60-$150 gallon for primer, $250 for sandpaper, masking tape, and masking paper on the conservatitive side, $40 a tube for automix seam sealer. So say $1500 on the short side for scuff and shoot for materials. Figuring at $3500 and $65/hr shop rate, that leaves 4 days of work to sand, prep, prime, jamb, reassemble, cut and buff. That is not gonna happen unless you run it to Maaco or it is damn nice to start with. A more realistic cost is going to be closer to $7k-$9k and that is not necessarily a show winner, but what I would call a very nice driver.