Gaetano have been complaining that his rear sway bar is too soft and well the budget wasn't there for a fabricated adjustible type so we came up with a fairly cheap solution and using the existing bar.
I loved the Pozzi bar that was used on Bad PennyŽ so we looked around for different types of bar adjusters. I found an interesting set made for polaris quads. Called them up to see if they had any in SAE sizes. Nothing for a .875 bar. Then I remembered a j-bar mount is very similar...no bueno for anything under 1.750 bar. Poop.
So I drew these up on solidworks and sent a copy to Dennis @ Creations Unlimited. He made a few tweeks. Contured the body so we can go from .625in to a 1.250 in bar with the same program. We made a prototype to try out on Gaetanos car.
I'll see how they do this month. So far so good.
Last edited by Vince@Meanstreets; 06-09-2013 at 12:50 PM.
|