Worked on laying out the dash. The center stack will hold a Stereo/cd player with navigation, a scanner, the A/C controls, and a CB. I need to extend the wires between the chassis and the face of the CB, so I can remotely mount the chassis as it is too long to simply mount.
In front of the driver there will be three gauges, a speedometer and tachometer that will operate of the '08 ecm, and a quad gauge that will use sending units mounted on the engine. The dash pad and vertical sides of the center stack will be covered in black vinyl. The dash fascia will be covered in brushed aluminum.
This is where and how I will mount the airbox. I need an elbow to come out of the box and pull air from in front of the core support. Once I get everything mounted, I'll cover the hole in the inner fender with fiberglass.
I made a heat blanket to protect the bottom of the evaporator case from the heat off the exhaust manifold. The manifold already has a heat shield as well, so the evaporator case should stay reasonably cool.
Until next time!