More progress....
I turned the frame on its side an bolted the front and rear sections of frame together. By cutting the frame at the centre of the rear cab crossmember it is very easy to reassemble.
Frame joined, you can see the 3 crossmember hole in the right side of the frame
Bolting in the crossmember
First hole drilled on the rear of the frame
Because 25 inches was cut from the frame it does tapper in on the rear section, by jacking and using a straight edge the rear was squared again there is a 3mm tapper in the rear frame section added....
Passengers side
Drivers side
The frame wont be welded till its back on the chassis jig and squared and set at ride height with is 6 inches to the lowest part of the frame under the cab....