Quote:
Originally Posted by carbuff
Sorry to be so non-committal, but it's just a tough question to answer unfortunately, and very combination specific.
|
You can't commit from what I've observed, these cars floor pan dimensions vary quite a bit. Motor mounts, subframes, crossmembers, body mounts, factory stamping variables, accidents, off-road excursions or jumping, 400 lb. drivers, etc.
My drivetrain angle is at 2.5* and when researching my install I found numerous "similar" cars that didn't any tunnel mods and numerous that need more than mine. I'm guessing there was a pretty generous tolerance when stamping the factory floor pan.
If I had planned on not using a console I would have cut the top off the tunnel and installed a section that was wider and flatter and incorporated an e-brake (Bat-turn) handle.