Installed a Baumann trans controller under the console and cut a hole for the digital readout & adjustment knob in the bottom of the console box.
Front end fitting!
The new C&R radiator being fitted for installation. This radiator was designed for a Chevelle / A-body, but does not bolt-in to a Skylark.
To fit the radiator with the factory mount, we had to modify! Part of it was cut and re-welded, and the mounting bosses on top of the radiator were utilized by drilling holes in the newly fabbed piece.
There was an air gap in between the rad & core support, we filled the gaps on either side by bending a couple of sheet metal pieces.
Determining placement of the ABS module
