Quote:
Originally Posted by tones2SS
These are great looking wheels.
Are you making these in a concave wheel?
|
OK there are 2 ways to interpret this question. I'm not sure which you mean, so I'll give you both answers.
1. Yes in any width larger than 9 inches, the SE1 is by definition the deep concave profile. (All 9 inch widths are built on the shallow concave profile. All others are on the deep concave profile.) My photos above might not do a good job of showing the concave angle. Try this:
2. If you mean, do we make a similar spoke pattern in a 3 piece Concave Series wheel, then yes...sort of. The DE3C Concave is a very similar 8 spoke version in a 3 piece concave. See:
http://www.forgeline.com/products/co...c-concave.html
And for fitments that don't require much outer, then you could also do the stepped lip version, the DE3C-SL. See:
http://www.forgeline.com/products/co...epped-lip.html