And more Jeepness!!
Made a place to hold the Chevy airbox. I cut a 4" hole in the bottom of the airbox, and made a tube to connect behind the front fascia.
Modified the airbox to close off the original air intake and instead use the new 4" intake tube. By the way, the welds are Silicon Bronze. Nice stuff to work with! Not for anything structural of course, but great for working with sheet metal.
A test fit with the lid.
Finished, except for the last flex joint and clamps.
I forgot to take photos of the build process, but here's the battery box (built out of the bed frame mentioned in the other thread).
I also made a bar to hold 3 Maxi Fuse holders and 4 Bosch style relays.
Lastly, I mounted a set of Cadillac 4-note horns (A, C, D, and F) in the old pie plate positions. They're not actually louder than the factory horns, but their tone really gets your attention!
No critters this time, though I wish I'd taken one of the Carolina Wolf Spider I found in the kitchen sink a few weeks ago! :shock: Egad that thing was huge!