Quote:
Originally Posted by mitch_04
So, I've read this entire thread and still haven't gotten better at TIG welding, what a crock.
Oh, you are supposed to practice as well? Hmm...
Anyways, I've just started TIGing with my main effort being sheet metal for body work. I'm trying to cut down on the weld finishing and warping. Any tips along those lines?
|
It's all in the prep and procedure. You will get better with time.
I have my prep together that I can put a patch in with no filler and very little finish work. This is after years of practice.
Get a few older scrap sections of the same thickness you will be doing and play with it. You'll find that it's all in material placement, fitment and heat control. Also try different temps and tungsten point sizes.
I run a low temp and a super sharp point on my tungsten.
picture is a patch on my old nova project. gap was .010 in, 4 tacs and no filler.