Quote:
Originally Posted by makoshark
Thanks Vince!
Are you talking about the 2 plates that Ridetech has revised the latest Airbar with that attach at the back of the floor pan seam? I just found out the other day they had made that revision and meant to call them about it. Did they use 1/8" to make those?
|
or 11g, looks closer.
On the channel, I welded up a 3 pieces to make a channel. The flat of the channel was contured to match the brake and fuel lines then sides were bent and shaped to match. Then sunk it in a bit deeper than the lines.
If I did it again I would have moved it forward a 1/2"