Quote:
Originally Posted by Firebird-Geek
Maybe it is a secret... but what is your new course of action? 
My plan was to sand the cars bottom, apply 2 good coats of epoxy primer, then seam seal and then shoot on Raptor. All this within 2 days, (to stay in the window of the epoxy primer accepting a top coat without need of sanding.) Did you figure out a better plan?
I am following your build very closely to absorb as much info as I can! THANK YOU for sharing all of you tips and ideas!  |
Thanks Jarrod and you're welcome
Your plan is fine. I've just been on the fence the whole time about putting the Raptor liner on the bottom of my car. When Musclerodz posted that improper prep work could cause problems I started to go back to what I had originally had planned from the beginning. Also, my father kinda talked me into it as well. I'm going to shoot bc/cc on the bottom of my car. I'm still going to use the Raptor liner, though. I'll just shoot it into the interior of my car instead. I really want to see blue in there as well, so I'll use it in there.
I looked at your build and you are doing one heck of a job on your car. I really like how you are being a stickler to getting all the body lines perfectly aligned. Your car is going to be very well built once finished.