I don't understand why it doesn't fit your 69 camaro, a 69 camaro is 1.5 inches wider in each fender compared to 67-68,
1) I would first set the camber, just from the picture I can see positive camber,
2) set the toe in also
and that will complete the install, there's a lot of factors involved to get it all in, and the inner fender well and inner fender lip on
ALL lowered camaros have to be modified that's why guys like anvil make a taller and wider inner fender well(in fiberglass and carbon)
heres a pic of there fender vs Stock
but I'm not rich so a little trimming and some aluminum to replace the cut out metal and I was done heres some pics
ok I did the fender mod a few months back and its not the most awesome one out there but its simple and I hope it helps you guys some
heres the car at ride height
remove the inner fender bolts all the way around
just leave the front one for now
and the lower rear will need a small button head when your done or you can leave it out if you want
you need a couple of these and some strong forearms or cut it the way you want
you can see were it rubs or just measure the center of the fenderwell and measure 16" x 7" rectangle these are my favs for basic trimming
drill a hole and start trimming,,,,,
instead of an empty hole I left half of the tin in place and bent it backwards to hold the wires and hoses between it and the fenders here is how the hole looks after trimming and rolling the fender edge, see 16 inches
heres the 7 inch measurement
then I made a simple card board filler patch template
the transferred to a thin aluminum diamond plate
bend it to fit the original template
and the I fitted it back into the opening
that's it!! when I replace the inner fender wells with fiber glass ones I will just mod those before I put them in and wont need to have the aluminum plates any more and this mod allows a ton of roll and no rub!!!
hope this helps!!