I didn't think I made much progress since the last update but, was able to get a few things done.
-Replaced the drivers side rear tail light panel
-Replaced the filler below the trunk
-Welded and panel bonded the trunk weatherstrip channels. I am really glad I have a shrinker/stretcher otherwise this really would have been a PITA.
-Stripped all the surface rust off of the trunk lid
-Fixed the majority of the dents on the PS quarter panel however, I will still need a bit of filler on the seams where I welded in the patch. Seems like every time I weld in a patch panel, I end up getting a pucker (low spot) where the seam is. If anyone has any suggestions, I'm all ears.
-Rebuilt all of the hinges
-Fixed the master cylinder backing plate to allow for the difference between the original firewall and the smooth firewall
-And the big thing, last night I looked outside and a big box is next to the garage...My Aeromotive Stealth Fuel Cell and cage built by Schwartz!!!
