[Z06vette]

My wayne due is an older version I believe. I bought it used quite a while ago, and it was originally set up for a big block. I had no issues with depth. I acutally cut the frame stands and shortened them to get the motor and trans down to 3 degrees from the 5 it was sitting at. I also had trouble getting the motor mounts lined up, as the stands were too close together and would bottom in the mounts, not allowing it to set down far enough to line the bolt holes up. I addressed this at same time that the mounts were shortened. Have you test fit the motor? If so post up some pics & lets see where youre running into issues. I'm using the stock F-body pan, if that helps you.
Scott