[gerno]

Driver side tub installed and I think I'm done with the major fab work. I have to say the second tub was much easier than the first. Beside the overall fear of cutting the car up the mini tub install was very straight forward and not too difficult. All that's left now is

-Seal tub seams and paint trunk

-Reinstall the rear suspension

-Lube the axle bearings and install the seals

-Connect the master cylinder

-Tighten all suspension bolts

-Bend up the brake lines

-Install the parking break cables

-Reinstall roll bar and all interior

-Pull SBC

-Install hydraulic clutch

-Install LS3

-Wire LS3

-Build exhaust

No big deal...that should be a week, right?