I haven't gotten much accomplished. I really need to shoot some primer and lay down some filler but, with the daytime high temps in the teens, that isn't going to happen anytime soon.
So, in the interim I decided to go ahead and plumb in my fuel cell. I shopped around a bit for lines and was going to go with the lines from Pegasus racing but, a bit too pricey for me. Instead I went with Aeroquip Starlite hose and fittings connecting the fuel cell to the Corvette filter/regulator. I will run one -6 line to the frame and it will connect to stainless hardline from there to the engine compartment.
The Starlite hose is very easy to work with. It cuts easily and the fittings are easy to install...Much more so than my last experience with doing hydraulic fittings with a crescent wrench and a vice.
The one change I will probably make is getting rid of the vent line and going with one of these PPM fuel cell vents
http://pitstopusa.com/i-5081296-ppm-...l-vent-08.html