Thanx for the explanation, it helped. I understand the full-floater rear end concept, what I didn't get was that the rotor/hat in this part was set up to 'float' in the radial direction. That wasn't obvious to me from the couple of pictures I have seen, but your explanation made it clear.
I'm actually contemplating changing my rear axle setup to use the Baer floater setup. I already have their rear Extreme kit, so I just need the adapter/hub kit. I haven't priced it yet, but since we are going to have to pull the rear housing to resolve a couple of leaks around some welds, that might be a good time for the swap. It will likely come down to whether we can get it done in the 3 weeks between events that I have or not. May have to wait until late March after the FW GG...
|