Gregweld,
I am hoping to build a car I can use on the street, a corner carver at open track and Auto-X events, and the occasional strip. It originally started as a car that I just wanted to improve the handling from original, but snowballed.
Here's the 8pt roll bar (1.75" chromoly) . I didn't want too much interference getting in/out of the car, but still not lose side impact protection and pass inspection at the track, if needed. I am extremely happy with the fit and detail, I believe Al at AVS did a fantastic job!
Second from last photo shows where the "NHRA" required(?)down bar ties into the frame rail connector.
|