[dipren443]

Ok, this next step is where the project goes off the deep end.

I purchased a DSE mini tub kit from a friend. At the same time, I bought a new (to me) MIG welder to replace the old Lincoln I had which had some serious issues. The cutting began... Got the passenger side tub in nice and tidy.



Then work intervened (I am a field service engineer in the Power Generation industry) and I spent the next few months on the road. As much as I hate traveling, the aspect of it is nice. Due to that and the fact I wasn't home, I sent the car back to G Force to finish the mini tub install... At the same time, I ordered a QuadraLink kit from DSE and 9", along with a 4 point roll bar, and Wilwood rear brakes to match the fronts.



In addition, the car was put on a rotisserie and the underside was stripped to reveal some of the cleanest sheetmetal the shop had ever seen. I had to pinch myself when I saw it. Not even a pinhole anywhere. The factory red oxide primer visible underneath undercoating that was painted on at some point too.