I have been following this post and have a question. I have a taurus fan and am getting the holley dominator which I want to make the fan powered by pwm. I was planning on get a solid state relay and send the pwm - signal to it to turn the relay on and off. I haven't checked any diagrams at work but looking at this module I am wondering is it just a nice looking solid state relay? The relay I plan on using is 4 wire so this has one extra wire, I think the extra one is + to fan motor?
Basically I would have
bat + to one side of the coil
pwm - to the other side of the coil
ground to fan motor from relay
ground from battery to relay
and I would have a + wire direct to the fan motor + wire
There would be fuses etc I was just making it quick for example. I like this module if its what I am thinking as its compact and looks more factory than a ssr, it would be nice to find the darn connector for it to finish it off though. So is it possible I could use this to power my taurus fan with my holley ecu?
Thanks to any one that can help out, this site has a lot of great info I have been taking in
