[eric1967]

Originally Posted by 57hemicuda

I'm running the Moser setup in my Mustang. The only advise I would give about ordering it, don't have them put a back brace on it. Mine showed up I put the brake brackets on it, painted it and put it in the car. When I drove it I could tell something was wrong, but on the trailer it went to the Motorstate Challenge. It was a spinning out machine, spun out like 3 times. Come to find out when they welded the back brace on, they warped the housing. 1.5 degrees toed out. Pulled it, sent it back, they did straighten it at no charge, but I did have to repaint it. Really cheesed m e off that they didn't check it first. Mines been OK since, also make sure you have them turn down the drive plates to chevy diameter or your wheels won't fit. I did fab a bracket so I could run Baer brakes with the emergency brake.

Nice work on the parking brake setup.