[walken100]

Ok, hopefully a simple question. I've had to re-layout my torque arm to allow for wider tires and some adjustability. Part of the work is adding a new sway bar. Turns out that a real clean place to mount the arms is near the end of the lower control arm. I know I've seen this done before and just wanted to see if there are any issues that I should be aware of especially from anyone that has done this. I am aware that this affects the actual resistance calculation through the range of travel but it seems like it should be inconsequential.

I've attached a picture of approximately where I would add the mount to the control arm.

Input is appreciated.

Bart