Quote:
Originally Posted by CURVES
Nice!
New desktop until mine is worthy.  |
Thank, that's a great compliment
Quote:
Originally Posted by Vince@MSperfab
finally a full frontal!! Looks great man.
I hope you can just off set the upper shaft. That would be the easiest option.
I wonder if the support rolled in a bit when it was cut and rewelded. We usually cross brace the hell out of that when we modify them. Ive seen a bunch under pressure when you cut the top.
|
There is an angled support on the car so I wouldn't have thought it would move but you should know more than me. Worse case I'm thinking I can use a cut off wheel to slice the support, push it forward and weld it up. This is by far the worse case. I'm hoping Blake simply has a solution for me since they know more of the complete engineering up the setup than I do.