Quote:
Originally Posted by GregWeld
It could have compounded an issue yes -- driveline speed would be higher.
My guess is --- it may have more to do with the output shaft of the tranny... and how much driveline is hanging out.
|
Funny you mention that because I measured how much yoke was left on the table today and was thinking the same thing.
Inland Empire supplied the shaft with the kit and I think they error on the short side. Ideally I'd like the shaft to be .3-.5" longer.
The measurement from the seal (which is very close to the end of the shaft) to finished surface of the yoke is actually 29mm or 1-1/8" at ride height.
As noted before you're the best guesser I know.
