Quote:
Originally Posted by Musclerodz
If its noticeable on decel, roll the pinion down further. I just had to reset a ridetech 4 link that had a vibration on decel. I would roll it at least 1-1.5* down if you have not done that yet.
|
Thanks, I've taken it past the best spot in both directions. After the last month I wish it was a 4 link!
I've done enough shimming to be pretty sure it's balance or the yoke penetration possibly.
The one change I did make to the previous setup was installing urethane bushings in the rear spring eyes (fronts were already in) I guess that in itself could have amplified a vibration condition but the difference was too drastic IMO.
Test drive window of opportunity is now!