Quote:
Originally Posted by Vince@MSperfab
is it a matter of tucking wires in?
|
No. Its in the design of the escutcheon type stamping. Its a washer like device that goes between the steering wheel and the hub adapter and contains the horn device with a snap ring, (may also act as a ground?.
The stamping's I.D. dimension exceeds that of the I.D. of the NRG part by probably 3mm.
So Vince, which screws did you get from McMaster Carr?
I'm in need of M5., and 15mm? Anodized black, countersunk, allens, prefered. Its too hold the wheel onto the NRG part. Couldn't find them at Orchard, and bought some that were 10mm long, but due to the "not seating", there too short. I used the ones from my Grant (but there's only 5 and there not quite the proper thread pitch).
Siegster, did you get the problem solved? i watched your build thread and you've got it solved? well 95%?