Quote:
Originally Posted by SSLance
I don't imagine that table flexes much, do all four wheels stay on the floor pretty well? Anyway to put locks on the wheels to keep the table from rolling once in place? And what all are you going to mount on the table permanently, like vises, drill presses, grinders and such?
I dig it, I'd jump on a deal like that in a heartbeat. Great work table.
|
I'll most likely leave it clear. I have a vice mounted on another worktop, same goes for sanders and grinder. Not sure on wheel stops yet.
Quote:
Originally Posted by Shmoov69
That is a killer table!! I got one for work from a Sheetmetal shop, just had to haul it off. It's 5'x12' with tongue and groove 2x top with steel corners all around and racks below for flat sheet stock. Just had to cut it down and put casters on it.
For my house I picked up a Wilton vice that the guy was going to scrap because it was seized up. After heating and pulling and such, finally got the rust to break free. A little cleaning and some new jaws, I have an $800 vice for under $100!!
I love other people's junk!! LoL!  |
5x12 would be nice........as is I'm a little cramped for space.
