Next steps on the project have begun. The SBC has been pulled and will be picked up today. I need to decide how much firewall cleanup I may do and possible wiring rerouting. I may also pull the entire subframe and swap it out due to the issue with the alignment and the fact that I need to set the panel gaps anyways. Still trying to figure that issue out. In the meantime I'm going to get the LS3 opened up a little to make sure everything is still in good shape there.
So far I've ordered up an oil pan from Pacific Fabrication and am placing an order for a hydraulic clutch kit from Vince. More parts are also going to be ordered up today.
