Quote:
Originally Posted by CURVES
I'd like to hear feedback on the torque arm as well.
I just began mocking mine up (I must have bought lucky 13. Lol)
So far I'm concerned with the fit of the rear x member, I will add plates to the frame to correct. Also it doesn't look like the trans can be dropped without un bolting the subframe.
The noise is something I hadn't considered. Keith, I'd be interested in hearing about any mods and results.
|
The rear X member is about 3/4" or so too wide. I welded 1/4" strips in, then welded x member to it. Trans should be able to be removed without issues. I would like to see the front x member made in two pieces, it was a PITA to install, and if you have sf connectors, good luck!