With all the working on the other car this poor car has been abandoned. Baer sent me a new brake set up before I went to Optima, I never had a chance to adjust anything before it left for Vegas. Car slid all over the track, front tires locked up at every turn. Adjusted the rear bias as much as possible, but still not a lot of rear brake.
While getting ready for Motorstate I decided to check the front to rear brake pressures. The first check, pushing as hard as I could, showed 2100psi front/ 400psi rear. Don't know what they are supposed to be, but I know that's not right.
Decided to ditch the tandem master cylinder with the rear bias adjuster, in favor of a dual master set up. Drilling the holes in the firewall was a real pain, but I did get it done. Made an aluminum cover for that mess, powder coated it, and will assemble it tomorrow.
The original set up definitely never worked considering I've cracked 3 front rotors, and the rears look pristine. This definitely a case of too many irons in the fire, this should have been checked/corrected years ago, just had too much going on. Building the car is easy, sorting it is the hard part.
