[Motobrewmaster]

Here is the info that Wilwood gave me to setup my prop valve.


1. Set valve all the way open to 100% pressure flow (turn knob clockwise all the way until it bottoms out).
2. Turn knob counter clockwise (4) full turns, this is the starting point.
3. With an assistant outside of the car to watching the rear tires, run the car up to no more than 20 mph then get on the brakes aggressively (panic stop).
4. Based on the assistant’s observation, do one of the following:
· If the rear tires skid at the same time as the fronts, then pressure will need to be taken away by turning adjustment knob counter clockwise in full increments and repeat the run. Continue adjusting until rear tires no longer skid.
· If the rear tires do not skid, then turn the knob in clockwise to allow for more line pressure in full turn increments. Once the rear tires skid, go back and turn the knob counter clockwise in full turn increments until the rear tires no longer skid.